Class-leading isolated DC-DC converter

Date
12/18/2018

Categories:
Boost, Buck, Buck-Boost, DC-DC Converters, Point of Load (POL), Power Conversion, Power Distribution, Power Factor Correction (PFC), Power Management, Power Measurement, Power Modules, Power Monitoring, Power Quality

Tag:
#flexpowermodules #psd #dcdc

 PDF
Flex Power Modules introduces its first generation of Direct Conversion products to address the growing need for higher energy efficiency levels.

The new BMR481 DC-DC converter has an input range of 40-60V targeting 48-54V nominal supplies, and a programmable 0.5-1.35V output. The 12 x 27.7mm footprint ‘main’ module provides a maximum output current of 70A and also incorporates a digital interface for monitoring, configuration and control purposes. This main unit can then be supported by up to 5 additional ‘satellite’ modules, resulting in a total current rating that reaches 420A.

The single-stage BMR481 provides an attractive alternative to the conventional two-stage intermediate bus converter (IBC) and point of load (POL) architecture – where an extra conversion step is required, which thereby takes up greater space and impacts operational performance. In contrast, this new groundbreaking Direct Conversion module presents engineers with a far more streamlined and economical solution. It is capable of achieving up to 92% efficiency from a 1V output at 53V in – which is 2-3% higher than what an equivalent IBC-based deployment can deliver. It also allows a reduction in board area of up to 50%. MTBF is in excess of 8.7Mhrs for the main module.

Optimized efficiency is achieved by automatic enabling and disabling of phases/satellite modules depending on the required load, along with dynamic voltage adjustment to provide optimum supply rails to connected ICs. Output ripple and noise is extremely low, typically 1mV p-p, due to the zero voltage/zero current switching employed. Load and line regulation are typically kept to just 1mV. At 53V input and 0.5V output, the full 70A output current is available from the main module to over 75°C ambient temperature with 0.5m/s airflow and to over 90°C with just 2m/s airflow. Full digital control is implemented with a PMBus v1.3 interface compliant with PMBus or AVS / SVID. Isolation is rated at 1500VDC (functional).

www.flex.com

Related articles

 3W Ultra-thin Isolated Regulated Output DC/DC Converters
 Fuji Electric 7th Generation IGBT Technology Powers Today’s High Efficiency Energy Conversion Systems
 Single-Layer MOVs Offer Superior Overvoltage Protection