>
>
Test & Measurement

 



 

 

Test & Measurement

October 2016
To read the November issue of PSDE, simply 
. . . Read More
Date:
10/31/2016
With fuel economy regulations tightening and autonomous-driving capability with connectivity proliferating, the old-fashioned 12-volt automotive electrical system has reached its usable power limit. Furthermore, a vast increase in automotive electronic systems, coupled with related demands on power, has created
. . . Read More
Date:
10/30/2016
When designing portable battery powered systems, size and battery life constraints are often the most severe challenges to overcome. One traditional way to pack a lot of functionality into a small size and power budget is to use a low power microcontroller such as TI’s popular MSP430. These types of ultra-low
. . . Read More
Date:
10/30/2016

The quest for energy efficiency has focused attention on those components of the power electronics that can connect hundreds of volts and amps in inverters with exceptional efficiency. We are talking about modern power switches – IGBTs and SIC-FETs – and how the voltage supplied to the respective gate drivers
. . . Read More
Date:
10/30/2016
High-voltage IGBT-modules usually consist of two types of IC, an IGBT for the transistor and a diode for the freewheeling functionality. A device that combines both functions in a single die is known as a reverse conducting IGBT (RC-IGBT). These modules exhibit a lower thermal resistance when compared to an
. . . Read More
Date:
10/29/2016
Multi-Layer Ceramic Capacitors (MLCC) in chipscale surface-mount packages are widely used in electronics for consumer, medical, industrial, automotive, and other applications. Their combination of affordability, compatibility with high-volume assembly, high capacitance values within small dimensions, and high
. . . Read More
Date:
10/29/2016
Equipment designs increasingly utilize advanced MCU, DSP and FPGA devices to deliver the functionality and performance demanded of them. With this sophistication comes the challenge of providing the multiple power rails these devices require. The use of carefully chosen power modules can significantly ease this
. . . Read More
Date:
10/28/2016
Here we’ll look at how a rugged and flexible control can be rapidly implemented using an 8-bit microcontroller with analog blocks. For many custom power supplies, this provides an optimum combination of noise immunity, high performance, short development time, and digital flexibility. Analog
. . . Read More
Date:
10/28/2016
People don’t think about engineers much, and in general engineers are looked upon in a positive light. Unless something goes wrong with something. In the marketplace, engineering is usually the first direction people point fingers when problems occur in a product. Unsafe and/or malfunctioning products
. . . Read More
Date:
10/28/2016
EVT offers 3D BGA inspection

EyeVision image processing software

Besides ensuring correct pin position, the EyeScan AT 3D sensor – together with the EyeVision image processing software – can also check for the flawlessness and position of the balls on a Ball-Grid-Array. The attributes of BGAs can be inspected with the 3D sensor for various characteristics with an accuracy
. . . Read More
Date:
10/25/2016
At electronica 2016, Rohde & Schwarz will showcase test solutions for advanced technologies, including those for fifth-generation mobile radio (5G) and wireless gigabit, along with state-of-the-art test systems for embedded designs and automotive systems. The electronica trade fair will be held from November
. . . Read More
Date:
10/21/2016
Toshiba unveils photorelays with up to 5A drive current

The TLP3547 is a 60V product with an industry-leading 5A (max.) large drive current

Toshiba Electronics Europe has introduced three new compact, DIP8 package products to its line-up of photorelays that can replace mechanical relays in industrial applications. The new devices - which include an industry-leading 5A large drive current – will suit a variety of applications ranging from heating,
. . . Read More
Date:
10/18/2016
A key consideration for wireless sensor nodes that will populate the Industrial Internet of Things (IIoT) is battery lifetime. The sensor nodes, in many applications, will need to be installed in locations that are difficult to reach and, consequently, service. Because it is too costly and difficult to run power
. . . Read More
Date:
10/12/2016
Oftentimes, designers of digital cameras, mobile devices and other consumer electronics choose to power their device from two, series-stacked, Lithium-Ion (Li-Ion) batteries, yet still desire the capability to charge from a 5-V universal serial bus (USB) port. Boosting a 5-V USB input to charge two series-stacked
. . . Read More
Date:
10/12/2016
Having a good grasp of how measurement tools actually operate can provide valuable insight into how test methods can be improved. Setups can subsequently be made simpler and more effective, plus test performance parameters can be significantly raised. This is true for any sphere of technology that requires the
. . . Read More
Date:
10/11/2016
LGA package technology can deliver important advantages for the high-performance Point-Of-Load converters needed to feed power-hungry, fast-reacting data centers and network infrastructure. As the power demands of high-performance Cloud and telecom computing systems continue to increase, converter modules that
. . . Read More
Date:
10/11/2016
Continuing the old story-telling tone which began the issue, I would like to point your attention to the centuries-old proverb “For want of a nail” which describes a chain of events and their consequences from a small error snowballing into catastrophe. There are many lessons to draw from this, from the
. . . Read More
Date:
10/11/2016
Here we’ll explore the analytical transfer function for the tightly-coupled Sepic converter. It is shown that the control-to-output function is just second-order, not fourth-order like the conventional Sepic converter [1]. The coupling capacitor of the converter has no effect on the control, and it can be
. . . Read More
Date:
10/10/2016
To read the October issue of PSDNA, simply   click
. . . Read More
Date:
10/08/2016
To read the October issue of PSDE, simply click here
. . . Read More
Date:
10/08/2016
The role of an uninterruptible power supply (UPS) is simple in concept: provide a temporary power bridge to support the load between the loss of the utility and the transfer to diesel generators. Even though the task is easy to define, the best way to achieve the goal is often clouded in obscurity as the benefits
. . . Read More
Date:
10/07/2016
Using EMC filters
EMC problems in frequency converters occur not only at the input, but also at the output. To ensure reliable elimination of any kind of interference at the output as well, companies like TDK, for example, offer a wide range of EPCOS filters and reactors. Frequency converters are used for regulating
. . . Read More
Date:
10/07/2016
Archives

 



 Home | Site Map | Contact | Privacy Policy | Refund Policy | Terms of Service | Copyright © 2018 Power Systems Corporation, All rights reserved 
X

Join Our Newsletter

Sign up today for free and be the first to get notified.