As the adoption of humanoid and collaborative robots is becoming more widespread, engineers have been tasked to fit motor drive electronics into smaller spaces. There are some areas of the humanoid robot, such as the shoulders, when there is sufficient space for a conventional drive and electronics, but for the wrists, ankles and other small joints, another solution is required.
According to Andrea Nicotera, Senior Firmware Application Engineer at EPC, the obvious solution to this problem is GaN, "lately robotics has been a focus for EPC as GaN can really shrink the devices, and this is what the market demands. While shrinking the size, we also increase the efficiency."
A conventional three-phase motor drive needs six discrete FETs and three gate drivers. The EPC solution for small robotic drives is based around the company’s EPC33110, a power stage that integrates three half-bridges and their gate drivers into a single package. All that is needed to complete the circuit is the microcontroller and the current sensor. That high level of integration ensures that the resulting solution is as small as possible.
The EPC91132 reference board was designed to highlight the capabilities of the EPC33110. It is designed for drones and for robotic joints where space is tightest. The small circular board is shipped inside a larger carrier PCB, making it easy to program and power during development. When the design is ready to deploy, the carrier snaps away and the board can be fitted inside the motor housing. The board acts as a complete drive, including the microcontroller, the EPC33110, and a Hall Sensor for more compact current sensing, along with a magnetic encoder for position control on the back. Programming pads stay accessible after the carrier has been removed. EPC chose an STMicroelectronics microcontroller for the board, mainly because of ST's motor-control software ecosystem. EPC supplies the board descriptor file that loads into ST's graphical tool, so engineers can select the board and motor and start tuning parameters right away. The magnetic encoder reads a circular magnet on the motor shaft to enable sensored speed control or full position control. Magnetic encoders are cheaper, more robust and easier to integrate than the alternative of optical encoders.
The EPC91132 reference board is aimed at BLDC motors and can accept input voltages of between 10 and 60 V, and up to 16 A constant current or 21 A in short pulses. The EPC33110 chip is rated to 100 V, but the board's on-board regulators limit it to 60 V. In general, robotics is moving toward higher voltages, but that trend mostly affects the higher power joints such as hips and shoulders, and not the small joints the EPC91132 targets. The board also includes the hardware for an RS-485 interface. There is no firmware support for it yet, but customers are free to use it for their own protocols.
Beyond integration, Nicotera highlighted two main GaN benefits. Firstly, GaN's higher switching frequency allows small ceramic DC-link capacitors in place of bulky electrolytics. The second benefit is that GaN allows much shorter dead time, at around 20 ns, which he described as more than ten times lower than MOSFETs. Shorter dead time cuts switching losses and reduces distortion in the phase current. As a result, motors run smoothly and quietly. It also removes the need for the complex firmware dead-time compensation that MOSFET designs often require.
For larger joints, EPC offers boards such as the EPC9176, which uses six discrete GaN FETs and handles much higher currents. Higher-voltage boards rated up to 150 V are also available. These boards use a standard connector with adapter cards for ST, Microchip, Texas Instruments and Renesas microcontrollers. EPC provides Gerber files, schematics and Altium projects so customers can move straight to their own production designs. The boards are not currently certified for production use themselves.